Bostitch CRN38K Specifikace stáhnout pdf (Strana 5)

BATTERY PACK OPERATION

CHARGING THE BATTERY PACK

• IMPORTANT – Charge the battery packs before using for the first time since they are shipped in a par-

tially charged condition. Two or three additional charges will be required before the battery packs are

fully conditioned and operating at full capacity.

• For best results charge the batteries in an ambient temperature between 40°F and 105°F.

• Batteries that have been used in the CRN38 for extended periods of time will become hot. If they are

hot when placed on the charger, the red charge indicator flashes until the battery cools to a tempera-

ture that is safe for charging. This cool off time will depend on the battery and ambient temperatures

and can range from a few minutes to over 30 minutes. When the battery has cooled, the charger will

automatically switch to the Rapid Charge mode.

• Use care when installing and removing the battery from the tool, do not press the trigger or the tool

may activate. Be sure to first remove the battery from the CRN38 before cleaning the nose or remov-

ing it for service.

STORAGE

• To get the longest battery life, ensure that the battery packs are discharged before being stored for

long periods (more than one month). Batteries can be stored in a dry location at any temperature

between –20°F and 120°F. They should be recharged before being used again.

BATTERY DISPOSAL

• Nickel cadmium batteries are recyclable and should be disposed of properly. Many state and local

laws make it illegal to dispose of these battery packs in normal trash or land fill

facilities. Recycle the batteries by dropping them off at local battery replacement

retailers or recycling centers. Look for the RBRC emblem.

Call 1-800-8-BATTERY for information about nickel cadmium battery recycling

and disposal.

Installation and Removal

• The battery is installed on the CRN38 Roofing Nailer by placing it on

the rails and sliding it forward until the latch engages.

• To remove, release the latch and at the same time slide the battery off

the rails.

TOOL OPERATION

EYE PROTECTION which conforms to ANSI specifications and provides protection

against flying particles both from the FRONT and SIDE should ALWAYS be worn by the

operator and others in the work area when loading, operating or servicing this tool. Eye

protection is required to guard against flying fasteners and debris, which could cause

severe eye injury.

The employer and/or user must ensure that proper eye protection is worn. Eye protec-

tion equipment must conform to the requirements of the American National Standards

Institute, ANSI Z87.1-1989 and provide both frontal and side protection. NOTE: Non-

side shielded spectacles and face shields alone do not provide adequate protection.

-5-

Battery Latch

• The CRN38 is a contact trip operated tool.

• For best operation hold the trigger in and press the tool against the work surface. Make sure to

push down until the tool stops against the work surface and turns off.

• The tool should be held perpendicular to the work surface or leaned back slightly.

1 2 3 4 5 6 7 8 9 10

Komentáře k této Příručce

Žádné komentáře

Bostitch CRN38K Specifikace Strana 5

Komentáře k této Příručce

Související produkty a manuály pro Elektrické nářadí Bostitch CRN38K